Tighten the bottom rail by pulling straight down. Tighten the middle rails by pulling diagonally down. Tighten the top rail by pulling across your body. To set the ring sling up, you want the ring sling to have just enough slack for your child to fit. When you're done, pull the rails gently outwards to re-tighten, and check for twists again. It's very common for the top and bottom rails to get twisted and cause problems, so take your time straightening. Use this to straighten any twisted fabrics. Find the top and bottom rails first, then "bloom" out the fabric in the center. Let's tweak the threading for a perfect carry. Straighten the fabric, then bring the tail over the top ring and under the bottom ring. Take the gathered tail and bring it upward through both rings. Check that the fabric isn't twisted.įinger walk the tail to gather the fabric without twisting. Pull the tail of the ring sling to the front of your body. Take your opposite side hand, reach behind you and find the upper rail. Step backwards and straighten the fabric.Ĭoming from behind, bring the rings to the opposite shoulder of the side you'll be putting baby on. Watch here! Read instructions by scrolling below.įirst, hold the carrier by the rings straight out in front of you. We'll be using a 100% linen, 71" long, gathered shoulder ring sling in print Lotus Gold, but you can use this technique to thread any ring sling. Thread your ring sling perfectly every time with these tips! Parent wears newborn in a Jurassic Park ring sling
0 Comments
Leave a Reply. |